Okay, you will need some type of desk drawer thingee or something like it.
Disassemble everthing:
You can take out the center divide with a screwdriver like this:
You should get something like this:
Cut the bottom board you took out earlier so it will fit the frame on top.
Put one of the cut board on top and your proto-board on it.
Make a hole where you will get your LCD cable and some LEDs through:
Solder on the 4pin connector male onto the bottom of the proto-board and you will get something like this:
Solder on 3 Blue LEDs on the bottom of the proto-board next to the male connector:
Solder on a 100 Ohm resistor from the end of the 3 Blue LEDs to ground:
Connect the 4-pin connector to 5V and ground:
