Here’s a fun DIY that shows you how to make a 2400 volt can crusher! Is that too much for crushing a can?
Well, I can think of many ways to apply this for can recycling, can you?
The promised and much awaited 2400 volt power supply went through its first test run. It was a little disappointing it takes 4 firings to get the can into the hourglass shape. One of the capacitors might be bad. Anyway a Microwave Oven Transformer charges six 400 volt capacitors through a 500 ohm 250 watt resistor
video://www.youtube.com/watch?v=zjTXUR4cKhI
I’ve seen camera mounts for motorcycles on the front by the steering but here’s a really radical DIY that shows you how to make a “rear” camera mount for a motorcycle that will fit on your rear peg, where normally a passenger would put his/her foot down.
This mount should support most digital cameras and small camcorders. You have the flexibility to position the camera either front or rear-wards. (or even install two at once!)
Be sure to put a small piece of tape over
