DIY – Ethernet Enabled Servo Motor Control in 1 hour!

Here’s a cool DIY on ethernet enabled servo motor control using CUBLOC CB220, XPORT, and Pololu Micro Serial Servo Controller by Thomas Edwards.

He also uses an Python Internet server to read the servo position information.

This was done in about 1 hour…pretty impressive.

via techartblog

related stories:

xport via techartblog

One Response to DIY – Ethernet Enabled Servo Motor Control in 1 hour!

  1. Izl says:

    So its a motor that can be controlled over the internet?

Leave a Reply

Your email address will not be published.


Check out more interesting categories: DIY, Microcontroller, Network, Robots.


Related News and Resources