Zedomax DIY122 - HOWTO Page 2
NEXT PAGE
Making the branches for the tree
Now grab your tub and shower knob, (yes take it out again…sorry) and place it about 1/3 of a page from the left like shown here and make a circle.
Now get something to draw a bigger circle than the circle you drew. I got my thread thingee that would do the job here. You should end up with a slightly bigger circle. This is so there is space in between the pipe and the plastic branch we are making.
Now we need a larger circle outside all the circles. This will be the actual outside layer width. Also draw lines outside the circle like shown here.
Now place another layer of the plastic binder on top of the circles you just drew.
We need a stopper which will not allow our bottom branch to climb when the speed of the PC fan is increasing. So make something like this:
Start cutting the plastic branches you made!
You will need two of these so make two:
Now fold the flap on the stopper we made and fit it through the pipe. Also get the plastic branch to fit under it too.
Now cut out some pieces of the plastic binder that you will be using as side branches:
Make sure the pieces are long enough by measuring from the bottom branch to the top of the PC fan for each side.
Tape them together if it’s too short:
Notice how I am doing it roughly here, but you could probably do a better job.
Tape the stopper:
Now tape it up like this just to see if it works:
Next, get the other branch we made earlier and put it in the middle like this:
NEXT PAGE
(No Ratings Yet)
Loading ...Related Posts
Bookmark It!
|del.icio.us |Digg it |Netscape |SiteHoppin |Wagg It | Email this to a Friend
Email This Page
If you like this post then please subscribe to my full feed RSS. You can also subscribe by Email.
Got a new hack, DIY, howto, or gadget? Tip us here.
No comments yet.