Zedomax DIY122 – HOWTO
NEXT PAGE
Parts list
- 1 CUBLOC CB220 Module
- 1 CUBLOC Proto-Board
- 1 PC Fan
- 8 High Output Green LEDs from Alan’s store
- 8 High Output Red LEDs from Alan’s store
- 1 Tub and Shower Knob
- 1 Tub and Shower Piping that fits the Knob (I used Watts 713322BA from Home Depot)
- 1 9V Battery
- 1 Plastic folder
- 1 Glue Gun
- 1 3M Tape
Tub and shower piping
Get your tub and shower pipe and stick it into the shower knob and screw in tight.
If should look like this:
PC Fan wrecking
Next, get your PC fan and cut out the 3 supporting legs as shown here:
You should get this
Now, pop it out
Putting tub and shower piping and the FAN together
Hot glue the fan to the screwable part on the tub and shower piping:
Now you can fit the fan power through the pipe so the wires end up at the bottom.
Finished Product should look like this:
Loading ...
