I have to admit that I have been blessed with lots of desire to learn new types of food.  Lately, I have been mastering the art of making Thai food, my favorite is Tom Kha Gai, which of course, requires some coconut milk.

Although I have heard that coconut milk is simply the juice from the coconut milk, I have never seen it in person but I did find this cool food hack on how to make coconut milk.

(Picture of coconut milk being extracted from coconut meat)

(Leftover coconut milk)

I think coconut milk has amazing taste when you make Thai food.  Of course, there’s many other Asian dishes you can make too but most of coconut milk in the world are still coming from Thailand.

Later on, I will have to post some pics on how to make Tom Kha Gai, it’s really good.

Squeeze out the ambrosia. They call it milk but it’s a lot like cream. Use it for cooking, making umbrella drinks. The mix of fats goes well with the deepwater fish you speared under that navigation buoy with your giant speargun.

Here’s a cool airplane hack on how to land a 747 just in case.

Main Checklist

1. Get on the radio, and tell whoever’s listening that you are landing a 747.
2. Engage a single channel of the autopilot — light one of the buttons labeled “CMD.” Point the heading indicator in the direction indicated to keep the plane straight and level.
3. Find the checklists in the side pocket of the pilot’s and copilot’s seat. If the plane is a 747-400, engage the Automatic Landing System (ALS). If it is not a 747-400, see below under “Landing Without ALS.”
4. If you can’t find the checklists, use these:
   1. Before Descent
      1. EO’s system check completed.
      2. Pressurization set.
      3. All a/c packs on. Set the airfield altitude so the plane is depressurized on landing.
      4. Humidifier off.
      5. HSIs: Radio. Switch horizontal situation indicators to radio navigation mode.
      6. Auto brakes: set.
   2. Approach Checklist
      1. P.A. cabin call: “Cabin crew 15 minutes to landing.”
      2. Cabin signs and exit lights: on.
      3. Ignition: on. This sets the engine igniters for landing.
      4. Fuel system: set for landing.
      5. Fuel heat: check/off
      6. QNH: Set. So the altimeters read the airfield altitude on touchdown.
   3. Landing Checklist
      1. Gear check: handle down, handle in, light green.
      2. Speedbrake: armed.
      3. Hydraulics: checked.
      4. Landing flap: set at 25 degrees.
      5. SCCM’s report: received. The cabins are secure for landing.
      6. Find the Jeppeson charts. Locate the radio frequency.
      7. Find the flight management system’s buttons on the glareshield marked LNAV and VNAV.
      8. Put the Jeppeson map on a 100 mile scale using the EFIS control panel on the front panel. You’ll get a yellow FMC message on the middle screen when it’s time to land.
      9. On the control display unit between the pilots’ seats, twist the knob until the little numbers go down to 100 ft. above field elevation in the Jeppeson notebook.
      10. Get the aircraft set to land: press the LOC and G/S buttons on the glareshield. All three CMD lights will go on, and the system will automatically tune to the right ILS frequency.
      11. 1Turn on the autobrakes when the plane starts descending.

via sampottsinc

Here’s a cool apple hack on how to replace the cells in your Apple Powerbook G3 if your batteries keep running out of time.

I decided to get new replacement cells from Battery Space instead of surplus cells at a slightly better price elsewhere. There are nine 18650 Li Ion cells in each battery, so I ordered 18 of them at a cost of about $100 with solder tabs. When they arrived, I carefully followed the instructions here to disassemble the first battery. It looked identical to the one in the photos there as you can see below.

via make

Here’s a cool hack on how to consolidate your menu buttons in Firefox 3.  It’s pretty easy to do but in case you don’t know how…

Just by moving a few small things around you can have all Firefox’s menu and location bar features, but without them taking up all the real estate.

via lifehacker

Here’s a cool hack on how to make a physical gmail notifier.  You could probably use any other type of LED RGB device too.

I was given a lovely glowing cube by the generous people at Linden Labs as a freebie at a job fair yesterday, and I decided that it was far too attractive to simply sit there on a shelf, pulsating forlornly until its batteries went flat. How about making it useful, while maintaining its visual appeal?

via hackszine

Here’s a great hack on how to make an iPhone LoJack and also be able to chart your location using GoogleMaps.

Basically the hack connects a Twitter account so your iPhone “twitts” your iPhone’s location at set intervals.  The “twitts” are basically GoogleMaps URLs that locates the GPS location of the iPhone.

How cool it that?  Pretty awesome I’d say.

If you’re traveling across the country, change your start interval to 15 minutes or a half hour and use a public Twitter account. (Remember to reboot after making changes to the Launch Daemon). Your friends will be able to track your progress using the Google Maps URL that’s tinyURL’ed into each tweet.

[via] tuaw