DIY APPLE HACK - Apple Bus Mouse garage door opener mod!
Check out this cool Apple Bus Mouse that’s been modded into a garage door opener. Brilliant!
So I got bored tonight and started going though my box-o-cables and came across an old Apple bus mouse I had gutted years ago. I always wanted to turn it into a garage door opener but never got around to it. Well, coincidently the garage door opener for my apartment parking is the perfect size to sit inside the mouse with room for a switch.
After some probing around the opener PCB, I found two easily accessible leads for the main switch, and used wirewrap to trace them out of the unit. Wirewrap around the terminals seemed easier than soldering them. With a $1.15 tube of Krazy Glue, a nylon washer and a PCB stand off, I got the switch just below the button so when screwed together it had about the same throw as the original mouse. I also tapped a lead from the LED on the board and ground to wire up a new LED where the old mouse cable went.
I took some pics, so take a look and remember, you would be amazed at what you can do with “junk”.
Thanks s1axter for the tip!
(No Ratings Yet)
Loading ...Related Posts
Bookmark It!
|del.icio.us |Digg it |Netscape |SiteHoppin |Wagg It | Email this to a Friend
Email This Post
If you like this post then please subscribe to my full feed RSS. You can also subscribe by Email.
Got a new hack, DIY, howto, or gadget? Tip us here.
k i have figuresd out a system… to get a few hundured in a few ghours… and i will tell noone…